We recommend you do not use the cigarette lighter
socket as some cigarette lighter sockets introduce an
unacceptable voltage drop.
The entire length of the cable must be dressed so it is
isolated from heat, moisture, and the engine secondar y
(high voltage) ignition system/ cables.
2 After the cable is in place, wrap heat-resistant tape
around the fuse holder to protect it from moisture and
tie down the full run of cable.
3 To prevent the risk of short circuits, disconnect other
wiring from the negative (
–
) batter y terminal before
Connecting the transceiver.
4 Confirm the correct polarity of the connections, then
attach the power cable to the batter y terminals;
red connects to the positive (+) terminal and black
connects to the negative (
–
) terminal.
Use the full length of the cable without cutting off excess
e v e n i f t h e c a b l e i s l o n g e r t h a n r e q u i r e d . I n
particular,never remove the fuse holders from the
Cable.
5 Reconnect any wiring removed from the negative
terminal.
6 Connect the DC power cable to the transceiver's
power supply connector.
Press the connectors firmly together until the locking tab
connectors firmly together until the locking tab
clicks
