1-866-771-2663 | Page 3
damaged part should this occur.
Only use the regulator and hose assembly provided with this unit. Replacement parts must be supplied
directly by Bond Manufacturing Co., Inc.
NOTE: You must follow all steps to properly assemble this heating item. Make sure the gas
valve is turned “OFF” before assembling. Do NOT attempt to assemble without proper tools.
•
Do not disconnect any part while unit is in use.
•
Do not store a spare propane tank on or near this unit.
•
If the heating unit is indoors, detach the propane tank and leave outdoors.
•
Y.
•
Always remove protective cover before operating (if applicable).
•
Do not set the protective cover over the unit until it is turned off and completely cooled down.
•
Check for leaks after not using the unit for long periods of time.
•
Children should never operate this unit. Children must be supervised while near this unit.
•
Keep gas tank at least 152.4 cm / 5 ft. away from unit when lit. (if external tank)
•
The maximum gas supply pressure is 250psi.
•
All installation and repair should be done by a qualified professional. This unit should be
inspected annually and cleaned regularly.
•
Inspect all elements of this heating unit before each use. If there is damage, the burner must be
replaced.
•
Be aware of the hazards of high temperatures and stay away from the unit to avoid any burns or
injury.
•
of the U.S. Department of Transportation or the National Standard of Canada CAN/CSA-B339, LP gas
tanks, spheres and tubes for Transportation of Dangerous Goods; and Commission.
•
Type I, (CGA791) LP
gas tank connection.
•
•
Inspect the gas hose and all connections to the propane tank prior to each use.
•
Always follow lighting instructions carefully.
•
Do not use
30 lb. propane tanks for this unit.
•
In case of high winds, secure this unit to the ground to prevent the unit falling over.
•
Children and adults should be alerted to the hazards of high surface temperatures and should
stay away to avoid burns or clothing ignition.
•
Young children should be carefully supervised when they are in the area of the appliance.
•
Clothing or other flammable materials should not be hung from the appliance or placed on or
near the appliance.
•
Any guard or other protective device removed for servicing the appliance shall be replaced
prior to operating the appliance.
•
Installation and repair should be done by a qualified service person. The appliance should be
inspected before use and at least annually by a qualified service person. More frequent cleaning
may be required as necessary. It is imperative that the control compartment, burners and
circulating airways of the appliance are kept clean.
Inspect the burner before use of this unit. If the burner shows any kind of damage, do not operate
the appliance. For assistance with repair or replacement of the burner or any other parts, call Bond
Manufacturing Co., Inc. at
1-866-771-BOND (2663)
