responsible for ensuring the current through the Metiri™ Smart Energy Meter does not exceed the Safe Operating
Current shown in the graph below.
If the Metiri Smart Energy Meter detects current exceeding the safe DC current level of 70A, the LCD will begin to flash
rapidly, warning the user. Allowing the current to exceed this value for sustained periods of time can result excessive
heat to the device and the wires connected.
DANGER
:
Opperating at currents above 50Adc can cause the Metiri wires, or the unit itself, to get extreamly hot.
You should never hold the Metiri Smart Energy meter by the wires with your bare hands or allow the wires to come in
contact with anything flamable.
HOME SCREEN
The default display is the screen shown when the Metiri™ starts up or if the ENTER button is touched in any other
SELECT screen. This is also the screen the Metiri™ will return to after 10 seconds of inactivity in any screen except
when scrolling through the Smart Energy Graph screen.
All measured values presented are in real time and updated at the same rate as the sample rate. The top right of the
display is programmable and is set in the
Set Home
screen. The bottom right of the display will show the time since
start in the format HH:MM:SS. If more than 24 hours pass, the time will roll over to 00:00:00 and will automatically
switch back and fourth from time to number of days passed.
For each day passed, Metiri™ will start a new data array for the Smart Energy Graph and will also start a new CVS file
for recording of measured data, if applicable.
SELECT SCREENS
Watts Screen:
Touching SELECT when on the
Home
screen will display power in watts on top. Bottom left will
display peak watts (P) and bottom right will display minnimum watts (M) recorded. The LCD will return to the Home
Screen after ten seconds or if the ENTER button is touched.
Home Screen
www.
GlobalTestSupply
.com
Find Quality Products Online at: