9
EN
G
LIS
H
Figure 14
Figure 13
7.2 Starting a warm motor
1. Place the grass trimmer on a flat surface.
. The spring switch (6) is always in the position ‘1’ and
does not need to be touched during ignition.
See figure 9.
. Turn the choke lever (9) down to the ‘COLD START’
position and then turn up the choke lever to its original
position. See figure 1.
4. Take a steady grip of the back handle.
5. Pull on the start line until a resistance is felt (circa 100
mm). See figure 11, then jerk the start line quickly until
the motor starts. This process can be repeated up to six
times in quick succession.
6. If the motor does not start repeat all of the steps in ‘Start
of cold motor’.
7.3 Switching the engine off
Release the throttle and let the engine idle, turn the ignition
switch (7) to “STOP”. See figure 14.
Helpful suggestions
Warning!
Remove all objects such as cans, bottles and stones from the ground before
starting to use the grass trimmer, otherwise they can be thrown about by the trimmer
line and cause injury or damage the trimmer.
Switch off the grass trimmer at once and check it for damage if you notice that something is
ejected or if the grass trimmer starts vibrating. Do not operate the grass trimmer if it has been
damaged.
Note!
Allow the engine to reach full speed before starting to cut the grass, never try to cut
grass at low speed.
Warning! Never raise the trimmer head above knee-height when it is spinning
.
Warning! Never use metal or plastic coated metal trimmer line, this could cause serious
accidents.
Summary of Contents for HY33PD-1
Page 55: ...55...
