1
EN
G
LI
SH
Fig. 24
Fig. 25
Fig. 26
0,635 mm
Fig. 27
8. Push the spool (B) into the housing whilst feeding the ends of the line through the holes (G).
9. Press down the spool (B), depressing the spring, tug the ends of the line, freeing them from
the slots (F) in the spool.
10. Push the assembled trimmer head onto the spindle, screw on the locking cap (A) clockwise
(only finger tight). (See fig. 5)
11. Cut the ends of the line so they are no longer than 1 cm.
9.2 Air filter, inspection/cleaning
Never use the grass trimmer without an air filter, clean or replace the filter if it is dama-
ged or dirty.
Clean the air filter like this:
1. Remove filter cover by pressing in the sides and lifting it
off.
. Remove the sponge dust cover filter.
. Wash the filter with soap and water. Do not use petrol!
4. Squeeze out water from the sponge and allow to dry.
5. Replace the filter and remount the cover.
6. Make sure the cover is securely in place so that it cannot
be shaken loose.
9.3 Adjusting the carburettor
The carburettor has been factory adjusted for optimum power.
9.4 Spark plug
Type of spark plug
: TORCH L8RTC, Champion CJ7Y, NGK BPMR7A
Recommended spark plug gap:
0.65 mm. Se fig. 7.
Tightening moment:
1 – 15 Nm.
Summary of Contents for HY33PD-1
Page 55: ...55...
