8
EN
G
LI
SH
Figure 10
Figure 11
Figure 12
13 cm
Figure. 8
Figure 9
7. Starting the engine
Note!
Pull the starter handle straight out, if you pull at an angle the starter cord will rub on the
sleeve and soon wear out. Keep hold of the starting handle after pulling it and allow it to return
slowly. Never let go of the starting handle straight after pulling it, it could get tangled or break
something on the trimmer.
Note!
See section “Troubleshooting” if the trimmer doesn’t start after several attempts.
7.1 Starting the engine from cold
Cut the trimmer line to a length of 1 cm before starting to
reduce the load while the trimmer warms up.
1. Place the grass trimmer on a level surface.
. The spring switch (6) is always in the position ‘1’ and
does not need to be touched during ignition. See figure
9.
. Turn the choke (9) down to the “COLD START” position.
See figure 10.
4. Push in the primer bulb (10) 6 times. (the primer bulb is
on the upper side of the carburettor.) See figure 11.
5. Take a steady grip of the back handle.
6. Pull on the start line until a resistance is felt (circa 100
mm). See figure 1, then jerk the start line quickly until
the motor starts. This process can be repeated up to six
times in quick succession.
7. When the motor has started, let it run idle for circa 10
seconds and then push the safety catch (1) and the
throttle lever (8) so that the choke lever automatically
returns to the ‘Drive’ position.
8. Before loading, let the motor run on ‘no-load’ for a while
until it responds to throttle increase.
Summary of Contents for HY33PD-1
Page 55: ...55...
