5
www.costway.com
4
www.costway.com
1.
Depress the spring clip in the middle stem
and insert it into the top stem(1) aligning
the clip with the hole.
2.
Loosen the middle stem’s lock nut in
the direction of the arrow. Then
insert the lower stem (2) into the
middle stem. Turn the stem’s lock nut in
the reverse direction of the arrow to lock
it in place.
3.
Unscrew the bolt of the control box(3) and hitch the control box to the
top stem. Then, insert the bolt into the assembly hole on top stem and
tighten it with the box.
4.
Wind the cable around the stem. Insert
the search coil cable plug into the five
pin jack at the bottom of control box’s
housing.
5.
When you stand upright with the detector in your hand, the search coil
is level with and about 0.5~2 inches / 1~5cm above the ground. You
can lengthen or shorten the stem basing on your height. After figuring
out the suitable length, then tighten the lock nut.
Caution:
The search coil cable plug fits into the connector only one way. Do not
force the plug or you could damage it.
ADJUSTING THE SEARCH COIL
Loosen the knobs at the search coil’s end, then adjust the search coil to the
desired angle. (The search coil should be parallel with the ground.) Tighten the
knobs just enough to keep the search coil from rotating or wobbling.
INSTALLING BATTERY
You need one 9V alkaline battery to power your detector.
Cautions:
Use only fresh battery of the required size and recommended type.
1. If the detector is on, turn the power off.
2. Press on the battery compartment cover and slide the cover off in
the direction of the arrow.
3. Connect the battery with the battery connector taking care of the
polarity. Then put the battery into the compartment.
4.
Replace the cover.
Cautions:
Always remove old or weak battery; battery can leak chemicals
that can destroy electronic parts.
If you do not plan to use the detector for a week or more, remove
the battery.
Dispose of old battery promptly and properly.
You can extend battery life by using earphones, which require less power than
the built-in speakers.
USING EARPHONES
You can connect a pair of stereo earphones (not supplied) to the detector so
you can listen to it privately. Using earphones also saves battery power and
makes it easier to identify subtle changes in the sounds you hear, for better
