7. YHC Configuration
YHC 700
7.2.2.1.4 Heat meters configuration
In this section you can specify:
•
The number of pulse counters managed (from 0 to 10). Default: 0
•
The polling time (the rate at which YHC700 will read the heat meters data - see NOTE
in section 7.2.2.1.1). Default: disabled.
•
For each heat meter you can specify:
o
Whether it is enabled or not.
o
The heat meter model (see section 2.4.2)
o
The heat meter address (Modbus or M-BUS address, depending on the heat
meter type)
o
The address of the BRG868 through which the heat meter is read, or the
option of the energy meter direct connection the RS485 bus. Default: bus 485
o
For M-BUS heat meters, the address of the gateway through which the meter
is read. Default: 0
o
A short description
7.2.2.2 M-BUS gateways configuration
In this page you can:
•
Read the M-BUS gateways main info
•
Remove the last M-BUS gateway of the list
•
Add a new gateway, by specifying:
o
The gateway model (see chapter 2.4.2)
o
Its Modbus address
o
The address of the BRG868 through which the gateway is accessed, or the
option of direct connection the RS485 bus. Default: bus 485
o
A short description
and importing the gateway configuration file
7.2.2.3 Cloud configuration
This page allows you to specify whether you want to use YHC700 to send the monitoring
24
