5
E 121 - DTU 614
C2 Eng.
04.07.01
We reserve the right to make changes without notice
COSTER
10.
3
Telemanagement Address
In telemanagement mode, controllers must have an address sequence number in order to be
identified by the central computer or by the local PC(s),.
Additionally, controllers can be subdivided into groups.
Note
When in non-telemanagement mode, the address should be saved (–).
To cancel values, press + and – keys simultaneously.
10.
4
Sending Alarms
•
Sending alarms
: NO = No alarms are sent
YES= Alarms are sent to the central computer and are signaled by the word
“ALARM” appearing on the display
•
Teleman Passw
: NO = Password disabled
YES= Password enabled
M3.
8
Ad d r e s s
:
–
G r o u p
:
–
M3.
7
S e n d i n gA l a rms : NO
P a s sWTe l ema n
: NO
10. COMMUNICATION
10.
1
C-Bus Telemanagement Communication (for more detailed information please see Technical Sheet
T 021)
Through the C-Bus output, DTU 614 can be managed remotely (two-way data communication) by
means of one or more local PC(s) and/or a remote central computer via telephone network.
From the PC(s) it is possible to view and/or change the following:
– data and value settings on the controller display pages, and configuration data dedicated to
telemanagement only (see “Technical Data”)
– system component’s operating status (pumps, accessory in general)
– acquire system-generated alarms
– view detector readings (temperatures: outside, room, flow, etc.)
10.
2
C-Bus wiring
C
0C
C
0C
C
0C
Controller
with Address
No. 1
Controller
with Address
No. 2
Controller
with Address
No. ...
to modem and/or
convertor for
local PC
