10
LIGHTING INSTRUCTIONS
Warning: If these instructions are not followed exactly, a fire or
explosion may result causing property damage, personal injury or loss
of life.
1. Open the tank drawer and find the control panel on the left. Make
sure the control knob is in the "OFF" position. See Figure 12. Open
the tank valve all the way.
2. Push in the igniter button. You will hear a slight clicking sound. With
the igniter button pushed in, push and turn the control knob to the
“
ON
”
position. The fire should light within a few seconds. Once the
flame is lit, release the igniter button and continue to hold the control
knob in for 10 to 15 seconds. Release the control knob. The control
knob should pop back out and the fire remain lit. Note: If the fire
does not light, turn the knob to the
“
OFF
”
position and wait five (5)
minutes before trying again.
3. To turn down the flame, push the control knob in slightly and turn to
Medium (medium flame), or Low (small flame).
4.
To turn off the fire pit, turn the control knob to the
“
OFF
”
position and
turn off the tank valve.
BURNER COVER ASSEMBLY
1. Place the burner cover on the table top as shown in Figure13.
WARNING: BEFORE PLACING THE BURNER COVER ON, MAKE SURE THE FIREPIT HAS
BEEN SHUT OFF AND THE BURNER HAS COMPLETELY COOLED DOWN.
Figure 13
Figure 12
