Costar CDI2528W, Installation Manual

Page: 9 / 18

Part 1 – Introduction
9
1
IR LED
2
Lens
3
Factory Reset Button
4
Wall/Ceiling Installation Hole
5
Bottom Cover
6
Network Port
7
Cable Access Hole
8
SD Memory Card Slot
• IR LED
A sensor inside the system monitors lighting
levels and activates the IR LED during low-lighting
conditions.
IR LED supported model only
• Lens
Features a fixed focus lens. You can adjust the
focus of the lens by turning the lens clockwise or
counterclockwise, and a focus fixation spring fixes
the lens position.
• Factory Reset Button
Restores the camera's default factory settings. For
more information, refer to the
Factory Reset .
•
Wall/Ceiling Installation Hole
Used to screw the camera in place on a wall or a
ceiling.
•
Bottom Cover
Allows you to install the camera on a wall or a ceiling.
• Network Port
Connect a network cable with an RJ-45 connector to
this port. If using a PoE switch, you can supply power
to the camera using an ethernet cable. For more
information on PoE switch use, refer to the switch
manufacturer's operation manual. You can configure,
manage, and upgrade this camera and monitor its
images from a remote computer over the network.
For more information on network connection setup,
refer to the
INIT operation manual
.
The table below shows the network cable specifications.
<The network cable specifications>
Item Content Note
Connector RJ-45
Ethernet 10/100 Base
10/100
Mbps
Cable
UTP Category 5e or
higher
Maximum
length
100m
PoE IEEE 802.3at, Class 3
• Cable Access Hole
For routing cables.
•
SD Memory Card Slot
Used to insert a microSD memory card into
the camera. (An SLC (Single Level Cell) or MLC
(Multi Level Cell) card by SanDisk or Transcend is
recommended)
• Do not remove the SD memory card while the
system is in operation. Removing the card while
the system is in operation can cause the system
to malfunction and/or corrupt data stored on
the SD memory card.
• An SD memory card is a consumable product
with a finite service life. Prolonged use will
damage the card's memory sectors and result
in data loss or memory card failure. Test the SD
memory card regularly and replace it whenever
necessary.