Page | 21 [email protected]
+1.818.937.0700 877.CAMERA.8 www.arecontvision.com [email protected]
Corner Mount
For a corner mount installation, the AV-WMJB wall mount, AV-CRMA corner mount, and MD-
CAP mount cap are required (sold separately). A corner mount should only be attached onto
hard corner surfaces including wood, plastic, metal, and concrete.
1. Using the Mounting template, prepare the mounting provisions for the camera installation.
2. Connect the wall mount cap and wall mount.
3. Attach the Junction Box Adapter to the Corner Mount Adapter
as shown in Figure 1.
4.
Remove the conduit plug on the junction box adapter and connect ¾” NPT conduit to the
junction box adapter
as shown in Figure 1.
Figure 1: Attach conduit to SV-JBA junction box adapter
Reference #
Description
1
Remove conduit plug
2
Connect ¾” NPT conduit to junction box adapter
(ensure use of water seal tape)
NOTE: Use silicon or water pipe seal tape to make sure no water leakage between conduit pipe
and junction box adapter.
5. Run the Ethernet cable and outside power cable (if necessary) through the supplied rubber
gasket and then through the Junction Box Adapter and AV-WMJB, Wall Mount Adapter. Ensure
the gasket is seated properly.
6. Attach the Wall Mount Adapter (AV-WMJB) to the Corner Mount Adapter (AV-CRMA) as shown
in Figure 2.
