Costar Video Systems D&N series, Owner'S Manual

Page: 15 / 32

22 23
1. TO CONTROL THE CAMERA VIA COAXIAL COMMUNICATIONS
CAMERA
BNC jack
CAMERA
BNC jack
1) Connect the of the unit and of the A1 Camera directly.
- For proper data communication, the unit and A1 camera should be connected directly.
(If you connect a DVR or keyboard in the middle of the main unit and A1 camera, bidirectional
communication will not be established.)
2) Connect of the main unit to a monitor’s video input terminal.
3) Setting the protocol and address and baud rate, please the next page.
VIDEO IN VIDEO OUT
VIDEO OUT
2. TO CONTROL THE CAMERA USING RS-485 DEVICE VIA COAXIAL
COMMUNICATIONS
1) Connect the of the unit and of the A1 Camera directly.
- For proper data communication, the unit and A1 camera should be connected directly.
(If you connect a DVR or keyboard in the middle of the main unit and A1 camera, bidirectional
communication will not be established.)
2) Connect of the main unit to a monitor’s video input terminal.
3) Connect TX(+/-) of RS-485 device to RX(+/-) of the main unit.
(For a full duplex system, connect RX(+/-) of RS-485 device to TX (+/-) of main unit additionally.)
5) Using RS-485 device, you can control the camera menu.
VIDEO IN VIDEO OUT
VIDEO OUT
4) Setting the protocol and address and baud rate, please the next page.
3. Setting
Please check the menu of your camera, and setting like below and also to match the
menu of your camera. For more setting information please check SCX-RD100 manual.
CCVC Connection CCVC Connection