COSMOGAS FRYO 6PI, Instructions For Installation, Use And Maintenance Manual

Page: 33 / 60

33
FRYO PI
COSMOGAS
7 - USE
7.3 - Sensors and system informations
All the temperatures detected by the sensors and the various
system information can be viewed on the display. To access
the parameters, proceed as follows:
1.- With the appliance on, press the and buttons
simultaneously for 5 seconds. The display will switch as
in Figure 7-10;
2.- Press the and button to view the various information
in accordance with the table below.
3.- Press the button to exit the menù.
Parameter Description Unit of measure
01 DHW setpoint °C
02 Heating supply temperature setpoint °C
03 Cooling supply temperature setpoint °C
04 Room temperature (N/A) /
05 Outdoor temperature °C
06 DHW temperature measured (Tw) °C
07 Heating supply temperature measured (Th) °C
08 Cooling supply temperature measured (Tc) °C
09 Room temperature (N/A) /
10 Water supply temperature °C
11 Water return temperature °C
12 Refrigerant temperature (“14” of Figure 4-1) °C
13 Supply voltage V
14 Current consumption A x 10
15 Compressor speed Hz
16 Evapo-condensing battery temperature (“25” of Figure 4-1) °C
17 Compressor discharge temperature °C
18 Suction temperature °C
19 Evaporation pressure (low) bar x 10
20 Condensation pressure (high) bar x 10
21 Expansion valve position 0 = completely open, 500 = completely close
22 Internal heat exchanger temperature system 1 (N/A) /
23 Voltage (V) system 1 (N/A) /
24 Current (A) system 1 (N/A) /
25 Compressor speed (Hz) system 1 (N/A) /
26 External heat exchanger temperature system 1 (N/A) /
27 Exhaust temperature system 1 (N/A) /
28 Suction temperature system 1 (N/A) /
29 Evaporation pressure system 1 (N/A) /
30 Condensation pressure system 1 (N/A) /
31 EEV position system 1 (N/A) /
32 Maximum safety supply temperature (N/A) /
33 Minimum safety supply temperature (N/A) /
34 Software version indoor unit (N/A) /
35 Software version outdoor unit 2 (N/A) /
36 Software version outdoor unit 1 (N/A) /
Figure 7-10 - Sensor and system informations
menù
Parameter
Value