Cosen SH-7550S, Instruction Manual, Page: 48 / 118

4 ‐ 14
Page 2 – cutting program setup
In this page you can set the following value (from top
to bottom):

Deviation ‐ Set deviation +/ ‐ tolerance value. If
value detected is out of this range for more than
15 seconds, error message will appear and cutting
will automatically stop.

Deviation On/Off ‐ Turn on or turn off the
deviation detector if installed.

Blade Used ‐ Current blade life in hours

Blade Life Reset ‐ Reset the blade life to zero

Error message (highlighted in yellow; can be
cleared by pressing down for 1~2 seconds)

Press Home to return to the main control menu.

Press PGUP to go back to the previous setup page.
Material cutting reference

This 2 ‐ page reference chart lists out the
required blade speed and cutting rate for each
different material.