Cosen SH-700DM, Instruction Manual

Page: 45 / 122

4 ‐ 13
ADJUSTING WIRE BRUSH
Follow these steps to adjust wire brush to appropriate position:
Step 1 ‐ Open the drive wheel cover.
Step 2 ‐ Adjust the fixed nuts to make brush move up / down until it makes proper contact with the
saw blade (see below illustration).
Step 3 – Close the drive wheel cover.
Proper Improper
ADJUSTING MATERIAL DEPTH BAR
Step 1 – Lift the saw bow.
Step 2 – Position the material according to your desired cutoff length.
Step 3 – Clamp the material securely with vise.
Step 4 – Lower the saw bow to allow about 10mm clearance between saw blade teeth edge and the
top of the material.
Step 5 ‐ Install the depth bar 1 and tighten the set screw 1.
Step 6 ‐ Loosen the set screws 2 and 3.
Step 7 ‐ Slide and position the depth bar 2 so that the end of depth bar 2 just touches the front of the
material.
Step 8 ‐ Tighten the set screws 2 and 3.
Set screw 1
Depth bar 1
Depth bar 2
Set screw 2
Set screw 3