Cosen SH-700DM, Instruction Manual

Page: 37 / 122

4 ‐ 5
Control Buttons
1. Power indicator lamp
When the lamp is on, it indicates the power to the machine is turned on.
2. Hydraulic on button
When this button is pressed, the built ‐ in ‐ light comes on and the hydraulic pump motor starts to
operate.
Press emergency stop button to stop the hydraulic system.
3. Saw blade start
button
When this button is pressed, the built ‐ in ‐ light comes on and the blade motor starts to operate.
Only if the workbed is at the front end or rear end of the stroke (front limit switch or rear limit
switch is actuated), the saw blade start button is available.
Make sure the workbed will not be damaged during cutting.
Vise has to clamp tightly or the blade motor will not work.
Press saw bow up button to stop the blade motor.
4. Emergency stop button
Press this button to stop the machine in an emergency. When the button is pressed, it brings the
machine to a full stop. The button locks when pressed. In order to unlock it, please turn the button
clockwise.
5. Blade speed indicator
The blade speed is shown here and the blade speed can be adjusted by blade speed control knob .
6. Blade speed control knob
This knob connects with the inverter and the inverter is used to control the rotation speed of the
blade motor. The blade speed indicator will show the speed variation while turning this knob. Turn
the knob clockwise to increase speed; turn counterclockwise to decrease.
7. Saw bow up button
When this button is pressed for less than 2 seconds, the saw bow rises until the operator lets go of
the button. When this button is pressed for more than 2 seconds, the saw bow will automatically rise
to the upper limit position.