Cosen C-260NC, Instruction Manual

Page: 60 / 132

4 ‐ 24
POSITIONING WORKPIECE FOR CUTTING
Follow these steps to position your workpiece:
Step Action
rear vises clamp material
1
Press the rear vise clamp button until the workpiece is
securely clamped.
align vertical rollers
2
Move the vertical alignment rollers toward workpiece
until it stands against the workpiece. Lock the vertical
alignment rollers by tightening the lock handles
feed material forward
3
Press the feed forward button until the rear vise touches
the front limit switch.
front vises clamp material
4
Press the front vise clamp button until the workpiece is
securely clamped.
rear vises retract to clamp
material again
5
Press the rear vise open button.
6
Press the feed backward button until the rear vises reach
back limit switch.
7
Press the rear vise clamp button until the workpiece is
securely clamped again.
front vises open; prepare for
precision position
8
Simultaneously press the front vise open button and the
rear vise clamp button to make sure the material is being
clamped.
confirm cutoff point
9
Press the saw bow down button to lower the saw bow
until the quick approach bar descends to just about
10mm (0.4 inch) above the workpiece.
Under no circumstances should the quick
approach bar be lowered below the height of the
workpiece.
precision position
10
Press the feed forward button (and the feed backward
button if necessary) until the cutoff point on the
workpiece aligns with the blade line.
front vises clamp material;
ready to cut
11
After the workpiece is correctly positioned, press the
front vise clamp button so the workpiece is securely
clamped.