STEP ONE
Connect the AC/DC adaptor to the DC Inlet, found on the rear of the
unit. Fasten the Security Clamp (found directly below the DC Inlet jack)
on top of the cable, so that it is not possible for the cable to become dis-
lodged.
STEP TWO
Connect the RCA Audio Outputs on both sides of the unit to a suitable
audio mixer. When connecting the unit, make sure you note that the Side
1 outputs carry audio from the left side deck, and Side 2 outputs carry
audio from the right side of the deck.
STEP THREE
Connect your primary USB device to the port found in the center of the
rear panel. You may choose any driverless device that follows FAT32,
NTFS, or HFS+ file systems. You may also connect a powered (active)
USB hub to augment the amount of available ports. If required, you
may also connect a device to the front USB port.
STEP FOUR
Press the Power button located in the center of the front panel. The unit
will take about 5 seconds to boot up as well as detect any USB devices
that are currently connected.
Using the HDC-1000
Preparing for Use
Fig 1.1 - Connect Power
Fig 1.2 - Connect Audio
Fig 1.3 - Connect USB
Fig 1.4 - Turn Power ON
10
