CORRECT CRAFT Ski 206, Owner'S Manual, Page: 7 / 84

the user presses and holds the start button, power is supplied to the ignition and
starter for as long as the user holds the start button down. All accessory
buttons are operational in this mode as well. Pressing the stop button will shut
off the engine and the unit is then put back in unlocked mode.
After the engine starts, release the start button.
Automatic Reversion to Locked Mode
If no keypad activity takes place for ten hours after unlocking, the system will
automatically revert to the locked mode. This helps to minimize battery drain.
Automatic Back-lighting
Pressing any keypad button will automatically turn the keypad back-lighting
on for ten seconds. This feature is useful for those that use their boat after dark
to find the appropriate keypad buttons.
Multiple Keyless Ignition Codes
The keyless ignition system has provision for three different ignition codes.
Any of the three codes may be used to unlock or lock the system.
The “Master Embedded Code” is programmed into the system at Correct Craft
Inc. and is not changeable, remaining with the boat for its life. This code can
be used to unlock the system, to lock the system and to erase the two user
codes.
The “Primary User Code” is programmed into the system by the owner with
the dealer’s help at the time of boat delivery. This code is used to unlock the
system, to lock the system, and to add or change the “Secondary User Code”.
The “Secondary User Code” is programmed into the system by the owner
when necessary. This code is only used to unlock or lock the system. The
“Secondary User Code” is excellent to use for limited access to the boat.
Programming and/or Changing Primary or Secondary User Code
Note: To help prevent battery drain, when you are finished using the boat
make sure you STOP the engine and LOCK the PME ignition system(two
steps). Note: The “System Indicator Light” is on the right-hand side of
theignition keypad. The “Ignition Indicator Light” is also on the left-hand side
of the ignition.
Programming the Primary User Code
Make sure that the system indicator light is off. Until a primary user code is
set, the keyless ignition will behave as follows. Pressing start once will unlock
the system while pressing it a second time will start the engine. Pressing stop
once will turn off the engine wheil pressing it a second time will lock the
system.
To program the primary user code, press buttons one and four at the same time,
1.3
Ski Nautique 206-July29-2003.qxd 8/6/02 10:05 AM Page 1.3