corob EVOFLX-LW, User Manual

Page: 34 / 45

COROB EVOFLX-LW
- 32 -
8.6 Cleaning the nozzle center (INV)
The autopad cleans the INV nozzle center after each dispensing.
When necessary, additionallly clean the nozzles as follows:
1. If it’s not open already, open the Autopad using the Off-line button.
2. Disconnect power supply (chapter 6.7).
3. Accurately clean the nozzles using a moistened cloth or the special cleaning brush that can be ordered as an
optional accessory.
4. Connect power supply and switch on the machine (chapter 6.6).
8.7 Cleaning and moistening the sponge (humidifier cap)
1. Open the cap.
2. Disconnect power supply (chapter 6.7).
3. Remove the sponge holding lid.
W I T H O U T H U M I D I F I E R :
a. Check the condition of the sponge and moisten as needed. The level of the humidifying liquid must not exceed the
height of the sponge. If it is very dirty, remove the sponge from the cap and wash it thoroughly.
W I T H SO LV E N T H U M I D I F I E R :
b. Check the condition of the sponge. If it is very dirty, remove the sponge from the cap and wash it thoroughly. Top up
with a small quantity of solvent the tank inside the sponge support; when repositioning the sponge on the filter, be
careful to dip the tail into the solvent.
W I T H WAT E R H U M I D I F I E R :
c. Check the condition of the sponge. If it is very dirty, remove the sponge from the cap and wash it thoroughly.
4. In all cases, if the sponge is severely damaged, replace it.
5. Re-install the sponge holding lid.
6. Connect power supply and switch on the machine (chapter 6.6).
7. Close the cap
.
d
In case of humidifier cap sponge replacement, use only those supplied with the machine
8 mm To remove the screw(s)
DANGER
IF THE MACHINE IS EQUIPPED WITH PUNCHING DEVICE
,
YOU MUST WEAR CUT-PROOF GLOVES.