corob EVOFLX-LW, User Manual

Page: 31 / 45

- 29 -
COROB EVOFLX-LW
7.6 Troubleshooting
Problem Cause Solution
The machine does not turn
on.
Power supply is missing.
Check the connections at the back of the
machine (chapter 6.6).
Main switch in OFF position
(0). Set the main switch to the ON position (I)
(chapter 6.6).
One or more fuses may be
blown up. Replace any blown fuse inside the fuse
compartment (chapter 6.3)
The power syupply unit is in
overcurrent.
Wait a few minutes and try to restart the
machine. If the problem persists, contact the
authorized technical service.
Electrical connections are
defective.
Contact the authorized technical service.
The management software
shows an error in the
communication protocol.
Machine is OFF.
Turn the machine on (chapter 6.6) and restart
the management software.
Machine disconnected from
the computer. Check the connections at the back of the
machine (chapter 6.6)
Computer serial port or USB
port wrongly configured or
defective. Use the configuration and calibration software
to make sure you have correctly configured the
port used to communicate with the machine
.
Serial cable damaged.
Replace the communication cable using
manufacturer’s original spare parts.
Connection defective. Contact the authorized technical service.
The WHITE lamp blinks slowly
and the machine refuses the
commands.
The machine is in the off-line
1 condition. Bring the machine to the on-line condition by
using the off-line button.
The WHITE lamp blinks fast
and the machine refuses the
commands
.
The automatic cap is open
and the machine is in the off-
line 2 condition. Close the automatic cap and bring the machine
to the on- line condition by using the off-line
button.
The machine does not work
and the
RED lamp is on.
Emergency button is pressed. Release the emergency button (chapter 4.6).
The machine does not work
and the
RED lamp blinks.
An error has occured.
Check the error message displayed in the
software.
After removing the cause of the error, restore the
machine by sending a reset command.
If the problem persists, contact the authorized
technical service
.