SCRN-530 Hardware Installation Guide | DOC-SCRN-530-HIG | 21 July, 2021 | Page 19
14. Disabling the LED Display
Step 1
From the CLI Configuration Mode, issue the
set System RadioNode LED
DefaultMode Dark
command to disable the LED display:
%set System RadioNode LED DefaultMode Dark
Step 2
Issue the
show System RadioNode LED
command to verify the
configuration:
%show System RadioNode LED
DefaultMode Dark;
15. Re-Enabling the LED Display
Step 1
From the CLI Configuration Mode, issue the
set System RadioNode LED
DefaultMode Standard
command to re-enable the LED display:
%set System RadioNode LED DefaultMode Standard
Step 2
Issue the
show System RadioNode LED
command to verify the
configuration:
%show System RadioNode LED
DefaultMode Standard;
Table 5 SCRN-530 LED Behavior
LED
Status
Flash Rate
Green: slow flashing The radio node or radio is
administratively disabled
Approximately ½ second on,
1½ sec. off
Green: fast flashing
Syncing
Approximately 1.4 second on/
off cycle
Green: solid
Operational
Red: solid
Fault
Blue: fast flashing
Locate radio node enabled (
Note
) Approximately 1 second on/
off cycle
Off
Powered off or LED disabled
Note:
Refer to the
Corning SCOS Administrator Guide
for information about the locate
radio node feature.
