Standard Recommended Procedure 206-337 | Issue 10 | August 2017 | Page 15 of 18
______________________________________________________________________________________
__
Figure 17
4.10 Splice Loose-tube Distribution Fibers to Connectorized Pigtails
This section describes preparing and splicing loose-tube fibers to connectorized pigtails. Refer to instruction
provided with splice tray as needed.
Step 1:
Place spiral wrap over the 900 micron pigtails in bundles of six or less. Use a separate piece of spiral
wrap for each bundle.
Step 2:
Attach buffer tubes and 900 micron pigtails to the splice tray per the instructions provided with the
splice tray
(Figure 18)
.
CO-side Tube In
Expressed Fibers Tube Out
Mark tube where it
enters and exits the tray.
Preroute
two loops
of fiber in
tray for
splicing.
CO
Cut only
the fibers
to be
spliced.
KPA-1776
CO Left
Mark tube where it
enters and exits the tray.
Preroute
two loops
of fiber in
tray for
splicing.
CO
Cut only the fibers
to be spliced.
Expressed Fibers
Tube Out
CO-side
Tube In
KPA-1799
CO Right