Standard Recommended Procedure 003-1002-AEN | Issue 7 | January 2019 | Page 13 of 25
Figure 19 — Install EDGE8™ Standard Module
4.8 Install EDGE8™ Port Breakout Modules
4.8.1 Into EDGE8-01U-SP, EDGE8-02U, and EDGE8-04U Housings
Step 1:
Starting with lower right corner (Tray 1, slot A), insert port breakout module from the rear until it locks
into place. Load all trays from right to left, bottom to top in the housing, as seen from the back.
Step 2:
Loop slack as shown in Figure 20, leaving enough slack to pull out trays without violating the
minimum bend radius.
Step 3:
Repeat for all modules.
Step 4:
Loosely capture ber slack with hook-and-loop straps, if desired (Figure 20).
Figure 20 — Install EDGE8™ Port breakout module
