Cornell CTP-E45T, User Manual

Page: 5 / 9

3. Never use the thermo pot near to the sink, bathtub, shower or any
other places that may contain water.
4. For first time use, boil the water in the thermo pot and then pour the
water away. This is to ensure that the thermo pot is in clean condition
before starting to use it.
5. You may notice a smell of plastic when boiling for the first time.
This is normal and will fade over time.
Operating Procedure
1. Open and lift up to completely remove the lid to add in water or you
may use other vessels like a kettle or jug to pour the water into the
inner pot. Keep other parts dry.
2. Add water till the
“FULL” mark. Do not fill water above the maximum
water level to avoid water flowing out from the dispenser.
3. Add water immediately when water is about to reach the refill level
mark, otherwise dry boil will occur.
4. Make sure the bottom of the appliance is dry. Always closed the lid
securely.
5. Do not plug in when the inner pot is empty. After filling the inner pot
with water, plug the power cord to the connector inlet and Mains
electrical supply. Then switch it on to boil the water.

Once the power is connected, the water boiling lamp goes on and
water is cooked directly. After water is boiled, the unit will produce a
sound. Then the unit will automatically turn into mode of temperature
preservation and the indicator of the function will turn on.

In the mode of temperature preservation, water will automatically boil
when water is added into the inner pot. When water is fully boiled,
the unit enters the mode of temperature preservation once again.
Note: When operating the unit for the first time, the default setting for the
temperature of temperature preservation is set as 85°C. The LED
lamp will indicate and blink at 85°C.