Cornell CFN-E161RC, User Manual

Page: 6 / 8

5

ON/OFF Button
Once the fan has been placed on a flat surface at the user desired position. Press
this button to ON the fan. The fan will start from the low speed which is the default
setting. Press the same button to stop the fan. The fan will stop immediately no
matter it is in any working condition.
Note: This fan is able to captured the previous mode used before switching off with
condition if the user did not switch off the main power supply. However, the preset
timing will be reset to default setting whenever switch off.

SPEED Button
Press this button once the fan is in working condition. There will be a light to indicate
on the fan panel every time when the user changes to their desired speed.

Oscillation Button
Press this “OCS” button to start the fan to oscillate. Press the same button again for
stop the oscillating function. There will be a light indicating on the fan panel if the fan
is in oscillation mode.

SLEEP/NATURAL MODE
Continuously press the speed button to select the mode function. There will be a
light indication in the fan
’s panel.

TIMER / PRESET
The fan can be set for timer or preset function.
- To use the timer function, press this button to set the shutdown time for the fan
while the fan is operation. The shutdown timing can be set from 0.5Hr to 7.5Hr.
- To use the preset function, press this button when the fan is in
“ON” condition but
not in operating mode. The user can also set their desired preset speed or mode
once the timing has been set. The fan will start to operate once it reaches the
preset timing. The preset timer can be set from 0.5Hr to 7.5Hr.
Note: The timer will increase by 0.5Hr each time when the button is pressed. The
maximum time it can be set for the both function is up to 7.5Hr.
OPERATION INSTRUCTIONS