Cornelius Brewed Iced Tea, Installation & Service Manual, Page: 27 / 58

Lipton Brewed Iced Tea Training, Installation, & Service Manual
May 7, 2002 - 19 630460171
3. Drip Tray Plumbing Procedure:
•
Permanent Drain Connection: It is highly recommended that
the drip tray be connected to a permanent drain tube. The
drain hole in the rear of the drip tray must first be drilled out
with a 5/16” (0.79 cm) drill bit. A plastic drain tube .50” (1.27
cm) outside diameter (not provided) should then be pushed into
the open end of the coupling. The drain tube must be routed
through the lower, rear opening of the housing. The exterior
drain plumbing must comply with local codes. A coupling is
provided to connect the permanent drain tube. The coupling
should be pushed over the 1/2” port on the drip tray.
•
No Drain Connection: Optionally, the drip tray may be
installed without connecting to a permanent drain tube. In such
case the drip tray will need to be emptied manually, and the
water heater over flow tube must not be emptied into the drip
tray. The overflow tube must first be disconnected from the
vertical nozzle hidden behind the center support of the lower
housing (must remove lower door to expose). Then the overflow
tube must be lengthened with a barbed splicer and a tube
extension not supplied with the dispenser. The lengthened over-
flow tube must then be routed through the lower, rear opening
of the housing. The exterior drain plumbing must comply with
local codes.
I
NSTALLATION
P
ROCEDURE
LBIT Installation and set up sequence
NOTE: Read all of these directions before starting installation.
NOTE: The LBIT must be installed with adequate backflow protection to
comply with applicable federal, state, and local codes.
WARNING: Failure to route the overflow tube away from
the drip tray could result in overflow of hot water from the
drip tray and cause personal injury.
WARNING: Battery Life
Disconnecting the power supply or turning the power switch
off for longer than 48 hours will result in a service call to
reprogram the dispenser. The battery will recharge itself
when the power is restored to the board.