Corega BAR-WL, Get Connected, Page: 7 / 172

ENGLISH
5
1.2 Front Panel LEDs
The following figure shows the front view of the BAR-WL Wireless Router.
• PWR (Power) Green Steady on when power is on.
• DIAG (Diagnostic) Red Light up during power on self-check. Not lit in normal operation.
• WLAN (Wireless LAN)
Enable: Green Steady on when AP (Access Point) is enabled.
Activity: Green Blinking when data is following through AP.
• WAN (WAN port)
Link: Green Steady on when ADSL/Cable Modem is properly connected.
Activity: Yellow Blinking when data is following through WAN port.
• LAN (LAN ports)
Link/Act: Green Steady on when link is up and it operates at 100Mbps.
Yellow Steady on when link is up and it operates at 10Mbps.
Green/Yellow Blinking when data is following through this LAN port.
FD/Col: Green Steady on when it operates at full duplex mode.
Off at half duplex mode.
Blinking when collision is occurred on this port.
1.3 Rear Panel & Connections
The following figure shows the rear view of the BAR-WL Wireless Router.
• Init Press the Initialization button quickly to reboot and re-initialize the device. Press the Initialization button of
longer than 3 seconds to clear any configuration and reset the router back to factory default values.
• WAN
This port is for connecting to the Wide Area Network ADSL or Cable Modem.
• LAN 1-4 These ports are used to connect computers and peripherals to the BAR-WL.
• Power
This socket is used to connect the external power supply to the router.
1
Link
Act
Link/Act
LAN WAN WLAN
Col/Fdx
100M
2 3 4
Power
Power WAN 1 2 3 4 Init