18
SPEED CONTROL SWITCH – cont’d
NOTE:
When blowing lighter materials
such as small leaves, set the speed
switch to "LOW". The lower speed will
allow the Power Cell to provide longer
running time. When blowing heavier
materials such as large leaves or wet
grass, set the speed switch to "HI". The
higher speed will produce increased air
flow for moving the heavier materials. It
will also shorten the running time of the
Power Cell before it requires
recharging.
WARNING:
Increased air flow
when running the blower at high speed
will cause debris to be violently thrown.
MOTOR CONTROL SWITCHES
To start the tool, squeeze the palm lock-
off switch (2) into the rear handle (3)
(Fig. 3). While squeezing the palm
lock-off switch, squeeze the ON/OFF
trigger switch (4). To turn the tool OFF,
release the ON/OFF trigger switch (4).
NOTE:
If the ON/OFF trigger switch (4)
is released without also releasing the
palm lock-off switch (2), to reactivate
the tool requires only squeezing the
ON/OFF trigger switch (4). If both the
ON/OFF trigger switch and the palm
lock-off switch are released you must
repeat the above procedure to restart
the tool.
ASSEMBLY AND OPERATING
!
Fig. 3
