- 8 -
Cod. 1910000000297 - nv00
User manual
English
*
The
SWING
and
ECO
keys are not enabled
1. General information
The user instructions as per this booklet refer to the remote-control
AH-018.
2. Operation
1 - ON/OFF
Switching ON/OFF.
2 - MODE
It allows you to scroll through the different modes of operation of the
fan coil, each time it is pressed the device switches to the next mode,
according to the following sequence:
AUTO > COOL > DRY > FAN > HEAT
The different modes are shown on the display of the unit controlled
by a special iconography and on the control by a small indicator
(see figure below).
• AUTO:
the unit will choose whether to operate in hot or cold mode
based on the detected ambient parameters.
• COOL:
The unit will operate in cooling mode (for correct operation of
this mode it is necessary that the system is properly set up and that it
feeds the fan coil with cold liquid).
• DRY:
The unit will operate in dehumidification mode (for the correct
operation of this mode it is necessary that the system is properly set
and that it feeds the fan coil unit with cold liquid. The conditions of the
environment are such as to allow dehumidification).
• FAN:
The unit will operate in ventilation mode.
3 - KEYS
By pressing these buttons, you can increase or decrease the target
temperature of the fan coil. The set temperature will be visible on the
display of the remote control and on the display of the fan coil unit.
4 - TIMER
It allows the delayed shutdown of the unit, each time it is pressed there is
an increase of 30 minutes, for a maximum delay of 24 hours (the remote
control must detect the unit for this function to be activated correctly).
5 - SLEEP
It activates the night mode; the device will set the set point temperature
2 °C below the target temperature and will set the ventilation to the
minimum operating speed. The activation of this function will be indicated
on the fan coil unit with a moon-shaped icon.
.
The function, when active, is not shown on the remote-control display.
6 - FAN
The
FAN
key can be used to activate the ventilation operating mode.
Repeatedly pressing this button allows the ventilation operation to be
changed in the following sequence:
MIN > MED > MAX > AUTO
The different modes are shown on the display of the unit controlled by a
special iconography and on the control by a small indicator (see figure
below).
1
4
2
5
3
6
7
Summary of Contents for Sofi HC
Page 6: ... 6 Cod 1910000000297 nv00 ...
Page 10: ... 10 Cod 1910000000297 nv00 ...
Page 14: ... 14 Cod 1910000000297 nv00 ...
