Cordivari Andrea, Operating Instructions Manual

Page: 19 / 98

- 19 -
Cod. 1910000000048 - nv07
To clean the stainless steel radiators you can use a non-
abrasive cloth dampened with water and methyl alcohol diluted
to 50%. Do not use detergents or aggressive substances. Avoid
any acidic or basic solutions, industrial chemicals or other
substances, corrosive or abrasive materials (bleach, ammonia,
soda ...) Do not use abrasive sponges or cloths.
5. Notice for the installer
The product purchased is subject to the general rules of
warranty so as written in the official Cordivari Catalogue in
force. The warranty starts from the date of delivery and is
void if the indication of the production lot is modified and / or
removed. The guarantee shall be effective after examination of
the defects and their relevant causes. The material to replace
or repair must be delivered at the retailer warehouse . The
obligation to provide the guarantee is subject to the conditions
and requirements set out below.
The radiator has not been damaged during shipping, handling
or installation and any repairs and / or modifications has been
carried out by a third party, if not expressively authorized by the
manufacturer . The material has been stored in good condition
and protected from the weather before being installed. The
installation of this product should be performed by qualified
personnel and in accordance with these instructions and all
safety equipment rules both national and local . Do not place
the radiators in rooms with the presence of chlorine vapours
or corrosive fumes such as swimming pools saunas, spa tubs.
6. Instructions for installation in Bathroom
The national rules on installing electrical equipment in the
bathroom must be scrupulously respected. The electric
radiators must be always installed outside zone 1 and 2.
The electric switch and control elements most be mandatory
located in zone 3, in order that no electrical control center is
accessible to anyone using the shower or bath
ZONE 0
ZONE 3
ZONE 2
ZONE 1
Install the radiator in such a way that the minimum distance
between the floor and the thermostat is 250mm and make
sure that there are no obstacles within a minimum distance of
100mm from the appliance.
7. Wall mounting
The electric radiaotrsmust be mounted on the wall following the
instructions provided in the packaging of fastening supports.
When the radiator is in the proper position, the resistor is
located at the bottom right.
The radiator must absolutely never be installed with the
resistor turned upwards or in any direction other than pointing
downwards, as the heating element in the resistor itself would
be irreversibly damaged during operation.
Never position the radiator in front of the power socket.
Make sure that the resistor never operates unless it is fully
submerged.
YES
YES
NO
NO
NO
8. Connecting up
All models of Cordivari electric radiator are fitted with a power
cable complete with a pre-mounted Shuko plug. Before connecting
up, make sure that the rated voltage of the appliance (230V)
corresponds with the mains voltage, and also check to ensure
that the wall socket is properly earthed in compliance with current
regulations and that it is capable of delivering the rated current
required to operate the chosen model at full power.
9. Cautions
When operating normally the radiaotr has very hot surface.
It is normal for the bottom pipes not to heat up.
Only warm towel that has been washed in water.
The resistors on electric radiators must never operate without
filling fluid, and for this reason the connections on the radiator
itself must never be opened.
In the event of accidental overheating and/or improper use, the
resisitor circuit may cut out. In this event the resistor can no
longer be used, and must be replaced.
10. Replacing of electrical immersion
Should it be necessary to replace the resistor, this must be
done exclusively by the manufacturer, by a person with suitable
qualifications, so as to avoid any risks.
ZONE 0
English