Corbin CA-RT-10 User Manual Download

Page: 4 / 4

13. Connect the pigtails from the wiring harness
and fuse adapter and push it back under the fuse
box.

14. Align the wire with the notch in the fuse box
cover and put back into place (Figure 25).

15. Put the waterproof cover back over the fuse
box and zip the liner close.

16. Be sure the ignition is turned off and you may
now plug the pigtail into the wiring under the
saddles.

17. Plug the rear saddle ABS rear braking
sensor system back into your Spyder.

Questions? Give us a holler...

800-223-4332

tech

corbin.com

FIG 21

FIG 22

FIG 23

FIG 24

FIG 25

Summary of Contents for CA-RT-10

Page 1: ...Figure 1 Next remove the three bolts on the inside of the trunk using a T 30 torx wrench Figure 2 Close the trunk lid and pull the trunkrest out Figure 3 2 Remove the two hinge bolts behind the seat...

Page 2: ...h Once properly aligned tighten securely NOTE Always open the fuel door when opening and or closing the seat on the hinge 10 Plug the ABS rear braking sensor system into your Spyder 11 Push seat down...

Page 3: ...it of silicone around the wire to help prevent water from getting through the notch in the fuse box cover 8 Remove the F510amp fuse in the fuse box and put it onto the supplied fuse adapter Figure 19...

Page 4: ...into place Figure 25 15 Put the waterproof cover back over the fuse box and zip the liner close 16 Be sure the ignition is turned off and you may now plug the pigtail into the wiring under the saddles...