2. Remove the right side panel (Figure 14).
3. Unzip the zippered liner in the front trunk to
gain access to the fuse box (Figure 15).
4. Remove the waterproof plastic cover, covering
the fuse box (Figure 16).
5. Remove the fuse box cover.
6. Remove the 20amp fuse in the middle of the
fuse box cover (Figure 17).
7. Make a notch in the fuse box cover using a
dremmel or file (Figure 18).
NOTE: Location should be 1/2” wide x 1/4” depth.
Start notch location on the edge where the flat lip
of lid corners up on the bottom right side.
NOTE: Put a little bit of silicone around the wire
to help prevent water from getting through the
notch in the fuse box cover.
8. Remove the F510amp fuse in the fuse box and
put it onto the supplied fuse adapter
(Figure 19).
9. Insert the fuse adapter back into the F5 fuse
slot (Figure 20).
10. Remove the 2 piece plastic fasteners on the
plastic cover in two locations (Figure 21).
11. Route the wiring harness under the plastic
cover (Figure 22) and then attach the ground wire
onto the bolt where the bike is grounded.
12. Continue routing the wiring harness under the
plastic side panel (Figure 23), out through the front
and down behind the fuse box (Figure 24).
FIG 13
FIG 14
FIG 15
FIG 17
FIG 19
FIG 16
FIG 18
FIG 20
Notch on
Bottom Right
Notch on
Bottom Right
