7. Remove the shock from the bike, by pulling out
the metal clip with a flathead screwdriver
(Figure 10).
8. Install the ABS rear braking sensor system
onto the Corbin saddle, using the stock bolts.
9. Install your Corbin saddle where you removed
the bolts in step two and secure using the stock
bolts. Snug the bolts, close seat to latch, then
tighten.
IMPORTANT: The Corbin hinge brackets are
adjustable. Only SNUG the bolts in the previous
step so that you can adjust position of the saddle
to latch. Once properly aligned, tighten securely.
NOTE: Always open the fuel door when opening
and / or closing the seat on the hinge.
10. Plug the ABS rear braking sensor system into
your Spyder.
11. Push seat down and latch into the stock
locking mechanism.
TRUNKREST INSTALLATION:
1. Remove the plastic trim on the stock seat. To
do this, give the plastic fastener a 1/4 turn, then
pop them out (Figure 11).
2. Install the plastic trim onto the bike by using
the stock bolts and plastic fasteners (Figure 12).
3. Install the Corbin trunkrest using the stock
bolts.
HEATER INSTALLATION:
1. Remove the two piece plastic fastener on the
trim panel, then remove the panel (Figure 13).
FIG 7
FIG 8
FIG 9
FIG 10
FIG 11
FIG 12
