18. Secure the lower position with the provided
bolt and flat washer (Figure 17). Do not tighten
yet.
19. Next, go back and tighten all three bolts. In
the top position, use a 13mm socket wrench and
open/combination wrench and use a 12mm socket
wrench for the bottom position.
20. Install the upper mounting bracket into the
turn signal bracket and secure the left hole with
the provided hex head bolt and flat washer and
secure the right hole with the provided hex head
bolt, flat washer and nylock nut (Figure 18). Do not
tighten yet.
21. On the right, install the upper mounting
bracket into the turn signal bracket and secure
with the provided hex head bolts, flat washers and
nylock nuts (Figure 19). Do not tighten yet.
22. Reinstall the left rear side panel.
23. Install the left side bracket by securing the
bottom position with the provided hex head bolt
and flat washer (Figure 20). Secure the top
position with the provided stainless steel stud,
using a 5/8” open/combination wrench (Figure 21).
24. Dissemble the turn signal by removing the
screw on the back with a Phillips screwdriver
(Figure 22). Remove cover (Figure 23). Remove
Allen bolt with a 3mm Allen wrench (Figure 24).
Carefully pull wiring out and disconnect
(Figure 25). Add wiring extensions.
25. Install left turn signal on the the Corbin
bracket (Figure 26). Run the turn signal wires
through the side panel and into the housing.
Secure housing, connect the wires and reinstall
the cover (Figure 27).
26. On the right side of the bike, remove nut,
washer and spacer on the exhaust hanger
(Figure 28). Discard spacer. Install the lower
bracket on the exhaust hanger and secure with
the stock washer and nut (Figure 29).
27. Reinstall the rear right panel.
FIG 17
FIG 19
FIG 21
FIG 23
FIG 18
FIG 20
FIG 22
FIG 24
