Normal mounting position.
Position with pivot point
away from hinge.
For Additional 15% Closing Force
Reposition arm mounting bracket so that
pivot point is toward hinge.
Standard Position
NON-HOLD OPEN ARM ONLY:
Attach Arm Bracket to Door
HOLD OPEN ARM (A1 Option):
Adjust Door Closer: See Page
FOR MAXIMUM
POWER
FOR REGULAR
POWER
Hinge
Pivot (away from Hinge)
80-9380-8000-152
Rev. 09/06
Away from hinge
Install with dial screw
facing down
DIAL
SCREW
FRAME STOP
90°
ARM
BRACKET
THREADED
ARM
SCREW
MAIN ARM
ARM ROD
SCREW
ARM
LOOP
90°
MAIN ARM
THREADED
ROD
ARM
BRACKET
MAIN ARM
Position Arm on Closer
Preload and Adjust Arm
Open door and slide arm rod into arm loop. Close door,
swing arms so adjusting arm is 90° to frame. With 7/16
wrench,
INSTALL and TIGHTEN SCREW SECURELY.
"
Main arm projects
straight out at 90° angle
to door. Install and
tighten arm screw &
washer assembly.
Extended Maintenance
NOTE:
DO NOT
Lubricate Arm periodically
with a drop or
two of appropriate lubricant.
When lubricating a
Hold Open Arm,
use any lubricant on the
Holding Surface components.
at
shaded points
Main arm projects straight
out at 90° angle to door.
Remove main arm screw
from elbow joint and
disassemble arm. Thread
the rod into the Arm Bracket
as shown below.
Install and tighten arm
screw & washer assembly.
While door is closed, adjust the Threaded Arm in
the Arm Bracket until the bearing fits back onto the
elbow joint on the Main Arm at 90 as shown below.
°
RE-INSTALL and TIGHTEN SCREW SECURELY.
NON-HOLD OPEN ARM ONLY:
HOLD OPEN ARM ONLY (A1 Option):
NON-HOLD OPEN ARM ONLY:
HOLD OPEN ARM ONLY (A1 Option):
7
E
D
F
G
DC8200 Jamb Mount Installation Instructions
Previous Page ( 6 )
This Page
A
C
B
F
E
G
D
6
8
#12-14 X 1-1/2 FH SELF-DRILLING (2)
OR
1/4-20 X 3/4 FHMS W/ SEX NUTS (2)
#12-14 X 1-1/2 FH SELF-DRILLING (2)
OR
1/4-20 X 3/4 FHMS W/ SEX NUTS (2)
5/16 HEX HEAD
SCREW & WASHER
ASSEMBLY
5/16 HEX HEAD
SCREW & WASHER
ASSEMBLY
