18
SE LP10 Integrated Wired
With and Without MELR Option (Electric Latch Retraction)
Copyright © 2020, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights
reserved. Reproduction in whole or in part without the express written permission of ASSA
ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Door
Position
Switch
McKinney
Electric
Hinge
Gr
een (NC)
White (C)
Wiegand Access
Control System
12VDC: Optional 24VDC
Lock Available
(Reader is always 12VDC)
8B Position Inside Escutcheon & Wires (MELR)
Fig. 8B (MELR)
1. Position escutcheon against door by
hooking the top edge on the top of the MELR
assembly. Verify that no wires are being pinched.
2. Mount inside escutcheon assembly to
plate using (1) #8-32 x 5/8" Phillips flat
head undercut machine screw (Figure 8B).
Machine
screw detail
8) Concealed Door Position Switch Instructions
1. Concealed Door Position Switch Model 708F989 is included with this product.
System integrator shall determine use and installation location.
2. Drill a 1" Diameter Hole for both the Magnet and the Switch. Both holes shall
be 1" Deep and for the Switch (if needed) drill a 1/4" hole for the wires.
3. Connect the common wire of the switch to the common input terminal of
the EAC.
4. Connect the normally open wire of the switch to the normally open input
terminal of the EAC.
