Cor Level Table, Assembly Instructions Manual

Page: 52 / 65

5 4
Assembly of the table top
3
To assemble the table top, two people should
carefully place the table top with the pre-
assembled cables on the assembled under-
frame. Make sure that no cables or plug con-
nections are crushed or damaged. Also make
sure that you have good access to the plug
connections of the cables. Now connect the
two motor cables lying on the plates to the cor-
responding connecting cables on the table top.
4
Align the plates so that the oblong holes are
aligned with the cross beam. Carefully move the
table top so that the oblong holes of the moun-
ting plates are level with the screwing points in
the table top.
ATTENTION
: Place the motor cables, including
the plug connections, in the milled areas provided
underneath the table top. Make sure that no
cable or plug connections are damaged or
crushed. First screw in one screw at a time
without tightening it firmly. Align the plate once
again by turning it so that all oblong holes are
located under a threaded sleeve. Now screw in
all the other screws and tighten all the screws
carefully.
GB