Cor Level Table, Assembly Instructions Manual

Page: 45 / 65

4 7
GB
3 Safety
The table described in the operating instructions has been built to the latest state of the art and is
safe to operate.
Hazards are secured in accordance with the regulations. However, the system can be dangerous
if it is used by untrained personnel, improperly or for purposes other than those for which it is
intended.
This can pose a risk to health, the system and the functionality of the system.
Every person entrusted with the installation, commissioning, operation or repair of the table
should read the operating instructions, especially the chapter „Safety instructions“.
Safety devices must not be altered in any circumstances.
If it becomes necessary to dismantle safety devices during repair work, the safety devices must be
reinstalled immediately after completion of the work.
The system may only be operated in perfect working order. Work requiring specialist knowledge
(e.g. electrical work) may only be carried out by specially qualified and trained personnel.
The table must be disconnected from the power supply before maintenance work is carried out.
Therefore, always observe the following 5 safety rules before starting work on electrical systems:
1. Disconnect the system from the power supply!
2. Secure against being switched on again!
3. Check that there is no voltage!
4. Ground and short-circuit!
5. Cover or shield any adjacent live parts!
Danger from residual energy!
Stored energy can also be present after the table has been switched off.
Residual energy or stored energy must be dissipated by qualified personnel
before working on the table!
Switch off / dissipate energy sources:
The safety regulations applicable to third-party devices are contained in the documents of the
third-party suppliers (operating instructions for purchased units).
Electrical energy:
The table is switched off by disconnecting the mains plug on the underside.