21
Network Camera User Manual
4.4
Alarm Configuration
Alarm configuration includes four submenus: Motion Detection, Alarm In, Alarm Out and
Alarm Server.
4.4.1
Motion Detection
Go to Alarm
Motion Detection to set motion detection alarm.
1. Check “Enable Alarm” check box to activate motion based alarm, choose alarm holding
time and set alarm trigger options.
Alarm Out:
If selected, this would trigger the external relay output on detecting a motion
based alarm.
Trigger Snap:
If selected, the system will capture images on an alarm and save the images in
SD card.
Trigger SD Recording:
If selected, the record will be triggered and saved in SD card on an
alarm.
Trigger Email
: If “Trigger Email” and “Attach Picture” checkbox is checked (email address
shall be set first in the Email configuration interface), the captured pictures and triggered
event will be sent into those addresses.
Trigger FTP
: If “Trigger FTP” and “Attach Picture” checkbox is checked, the captured
pictures will be sent into FTP server address. Please refer to FTP configuration chapter for
more details.
2. Set motion detection area and sensitivity. Click “Area and Sensitivity” tab to go to the
interface as shown below.
