Setup of the
Dome Camera
4
5
6
2400bps
4800bps
9600bps
19200bps
Baud Rate of
Communication
DIP-1
DIP-2
DIP-3
DIP-4
DIP-5
OFF
ON
OFF
ON
DIP-6
OFF
OFF
ON
ON
Setup of Baud Rate
Setup of the Baud Rate of Communication.
As shown in Figure 2-1 & 2-2, SW2 is used to set the protocol of communi-
cation and the baud rate used by the dome camera. DIP-6 and DIP-5 of SW2
are used to select the baud rate of communication and 4 different baud rates
can be selected in maximum. If the controller adopts non-standard baud
rate, you can adjust it to be identical with that of the main machine as per the
following table.
Selection of the Terminal Resistor of the Dome Camera.
As shown in Figure 2-1 & 2-2, JP1 is the select switch of the 120
Ω
terminal
resistor on the bus RS485, on which only one terminal resistor of the dome
camera at the farthest end can be connected, while the terminal resistors of
other devices should be opened.
Shortcut control function
30
Set Preset
Reserved
Close the menu
Reserved
Reserved
Reserved
Reserved
Reserved
Close the menu
Reserved
Reserved
Reserved
Reserved
Preset
1
64
90
91
92
93
94
95
96
97
98
99
Call Preset
Tow Preset Open the menu
Open the menu
Reserved
Run first patrol
Scan limit to left
Scan limit to right
Reserved
Open the menu
Stop scan
Auto scan
Reserved
Reserved