9
Press
[CALL] + nnn + [ENTER],
the onscreen display shows
：
CALL PRESET
：
nnn
nnn = the number of the preset position: 1~128
2.3.3 To delete a preset position
：
（
Only be effective to Protocol COP-2. Some special keyboards no function
）
Press
[CLEAR] + nnn + [ENTER]
, the onscreen display shows
：
CLEAR PRESET
：
nnn
nnn
=
the number of the preset position which will be deleted.
2.4 Tour Functions:
2.4.1 To perform a preset sequence tour:
Press
[CALL] + 53 + [ENTER],
will scan automatically from No. 1 preset in order through to No. 16 preset position. The
cruise will not scan positions that are un-preset or deleted. The dwell time for each preset position is fixed at 3 seconds.
2.4.2 To perform a Horizontal Point to Point scan function (Auto Pan):
Move camera to view start position - Press
[AUTO] + [ON]
To select the start position of the horizontal scan
Move camera to view the end position - Press
[AUTO] + [OFF]
To select the stop position.
Press
[AUTO] + [ENTER]
To start the scan function.
The camera will scan automatically between two designated positions, namely “starting point” (left) and “end point” (right).
The dwell time at “starting point” and “end point” is 3 seconds; states of dome camera are shown below. The dome
camera will stop scan and implement new action when receiving qualified command.
Note:
The dome camera may result in accumulative deviation in parameters after operating the scan for a long period.
The starting point and end point of scan shall be reset on a regular basis or as part of a planned maintenance program.
2.5 Auto Resume
2.5.1 Auto Resume Tour (Auto Home)
To enable the camera to resume it’s preset tour after a period of 5 minutes inactivity on the joystick keyboard controller
press [CALL] + [90] + [ENTER] to disable the feature press [PRESET] + 53 + [ENTER]
2.6 Title Display:
2.6.1 Zoom status confirmation display
This on screen display shows the current position of the Zoom lens i.e “ZOOM X 18”. To remove
“ZOOM x nn”
from the
display – Press [CALL] + [64] + [ENTER] to enter the Hitachi camera module OSD menu set-up (page 29).
2.7 Special Function:
2.7.1 Power-off Protection
When the camera is operating a scan or cruise track and a power failure occurs, the camera will store the operation it
was functioning before the power-off. When power is reapplied, the camera will continue to perform the scan or cruise
track automatically under the same state before power-off. Should scan or cruise track not be operating before power-off,
the camera will move to the first preset position automatically after power on self test routine.
Note:
This is a fixed function and cannot be disabled.
2.8 Camera Reset
Press [PRESET] + [54] + [ENTER] to reset camera titles and settings.
