ELECTRIC PATIO CLEANING BRUSH
–
H062
Instructions for Use
Please read and retain these instructions for future reference
v001: 19/02/20
Page No. 7
Never start the equipment when it is turned over or not in the correct working position.
Switch off the motor and disconnect the plug from the mains socket:
-Whenever you are not using the equipment
-If the equipment is left unattended.
-When the equipment is being cleaned, maintained or is to be inspected.
-When relocating the equipment.
-If the power or extension cable is damaged.
-When you remove or exchange the cutting device or manually adjust the length of cutting line.
Never try to stop the brush with your hands. Always wait until the brush stops rotating.
Do not use the device for removing weed or moss not growing on the ground, i.e. moss growing on
walls or rocks etc.
Always inspect the brush before starting the device. Never use damaged brushes. Replace any
damaged or worn brush.
The brush must not be mounted on device with an engine speed exceeding the admissible maximum
engine speed of the brush.
Do not traverse gravel paths while the equipment is operating. Gravel can be thrown up and result in
injury.
Do not operate the equipment in the vicinity of inflammable liquids or gases as they could give rise to
the danger of a fire or explosion.
Store the equipment in a secure dry place that is not accessible by children.
CAUTION!
The following states how damage to the equipment and possible injury to people can be
avoided:
Taking care of the equipment:
Ensure that the ventilation openings are not clogged.
Only use spare parts and accessories that have been supplied or recommended by the manufacturer.
Never try to repair the equipment yourself. All work that has not been listed in these instructions must only
be carried out by an authorized servicing agency.
Treat the equipment with the greatest care. Always keep the equipment clean for better and safe work.
Follow the maintenance instructions.
Never overload the equipment. Always work within the stated capacity range. Do not use low-power
machines for heavy-duty work. Do not operate the equipment for purposes for which it is not intended.
Always inspect the equipment before it is to be used. Do not operate the equipment if safety devices, parts of
the cutting device or bolts are missing, worn out or damaged.
ELECTRICAL SAFETY:
CAUTION!
The following states how to avoid accidents and injuries due to electric shock:
