ELECTRIC PATIO CLEANING BRUSH
–
H062
Instructions for Use
Please read and retain these instructions for future reference
v001: 19/02/20
Page No. 11
Always unplug the device before working on it. There is a risk of injury.
Observe the noise protection and other local regulations.
SWITCHING ON AND OFF
1.
Loop the end of the extension cable and hang it onto the cable tension relief (4) to ease the tension on
the cable.
2.
Plug the tool into the mains.
3.
To turn on, use your thumb to actuate the switch lock (2), then press the switch trigger(3). Release the
switch lock.
4.
To turn off, release the switch trigger (3). There is no continuous operation mode.
The brush will keep rotating for a few seconds after the device has been switched off. Keep the brush
away from hands and feet.
Do not try to lock the switch trigger in place. Do not use the device if the switch is damaged.
A damaged switch may cause an injury risk due to the motor not being switched off after releasing the
switch trigger.
DEVICE ADJUSTMENTS
Length adjustments:
The telescopic arm enables you to adjust the device to your individual height.
Unfasten the lock knob (7), adjust the telescopic arm to the desired length and re-fasten the lock knob.
Adjusting the splash guard:
You can adjust the splash guard (11) by sliding it backwards and forwards.
Setting the rotation speed:
There are infinitely variable speed controller setting on the speed regulator (1).
PRACTICAL TIPS
Caution, risk of injury!
Always inspect the brush before starting the device. Never use damaged brushes, replace any damaged or
worn brushes.
Use original brushes only.
