number
Hard Skin Remover
10243
Instructions
v1.0: 17/11/15
Battery Installation:
Remove the battery cover by turning the cover lock anti- clockwise, then pull the cover away from
the body of your device.
Inset 2 x AA alkaline batteries into the compartment, ensuring to observe polarity. Please note that
incorrect battery positioning can damage your product.
Refit the battery cover and turn the lock 90 degrees to secure.
Use only the batteries recommended.
Insertion, removal and disposal of batteries should be done by an adult.
Remove batteries from product if not using for a long time.
Store batteries in a dry place at room temperature.
Operating Instructions:
For best results, wash and fully dry skin before use.
Remove the protective cover from the device and it is ready to use.
Ensure that the buffing roller is correctly placed into the device
.
Turn the device on by pressing the safety lock, whilst simultaneously pushing the on/off switch up.
Gently rotate and glide the device over the desired area. The device will stop if it is pressed too hard on the skin.
Check if you have achieved the softness you desire. If not, gently glide the device over the area again for 2-3
seconds further.
Turn the device off when finished.
Warning:
Stop using is skin becomes irritated or sore.
Do not use on skin continuously for more than 2-3 seconds at a time.
Cleaning:
To ensure better performance, clean the device after each use.
Detach the buffing head from the body and rinse under the tap after each use.
Allow to dry before attaching the head to the body of the appliance.
Changing the Buffing head:
Change the buffing head as needed for best results. One extra buffing head is included for each unit.
Ensure the unit is off.
Hold the head with one hand, and press the release button on the side of the unit using the other hand, the head
can be lifted out and replaced.
Place the new buffing head into the unit until you hear a “click” sound, this will ensure that the new head has
fully installed properly.
