Cooper Scantronic 9448, User Manual, Page: 5 / 12

496572 5
UK
If the Panic light (zone 6) glows then deal with the
cause of the alarm first. Next, reset the panic button,
then switch the alarm system bells off and reset the
system (see above).
TO TEST BELLS
Make sure system is unset before starting the test.
Key in 4 then ENTER followed by your user code.
The internal sounders will operate for three seconds
and then the external sounder and strobe will
operate for three seconds.
TO WALK TEST
Key in 5 then ENTER, followed by your user code.
The internal sounder gives a steady tone.
Open and close the Exit/Entry zone and zones 1 to
4. (Open and close zone 5 if it is NOT a fire zone,
and zone 6 if it is NOT a panic button.) Each time
you open a zone, the internal sounder gives a
pulsing tone.
You cannot test the 'Tamper Circuits' without
creating an alarm condition. Similarly, a panic button
will always cause a full alarm.
To stop walk test, key-in your access code.
TO READ THE LOG
The system keeps a log of the last ten alarm or
tamper events. To read the log key in 8 then
ENTER followed by your user code. The system
switches on the zone or Tamper lights to show you
the most recent event. If you want to see earlier
events then press ‘<<‘ (the 1 key). To see more
recent events press ‘>>’ (the 3 key). The keypad
gives a short tone when you reach either end of the
log. To leave the log press OMIT or ENTER.
4
? ? ? ?
Trigger Detectors (Not Panic
Alarm)
5
? ? ? ?
? ? ? ?
Keypad shows most recent
event.
8
? ? ? ?
<<
>>
Earlier events.
Later events.