Cooper key-kp01, Installation Manual

Page: 7 / 16

Page 7
KEY-KP01
Introduction
The KEY-KP01 keypad is designed to work with the i-on range and Menvier
30/40/100/300 series of control units using software version 4.03 and higher.
The keypad allows users to set and unset an alarm system and installers to
program the system. The keypad has backlighting for the keys and display. The
the ABCD and Navigation keys have status LEDs integrated into the keys them-
selves. In addition the KEY-KP01 contains:
An integrated proximity tag reader
Terminals for an external proximity tag reader KEY-EP (not supplied).
Please note that control units with software versions lower than 4.03 cannot
use the external prox reader.
Keypad Controls and Displays
Figure 1 shows the controls and displays available on the keypads:
To open the unit, unclip the caps covering the screws on the front (item 5 in
Figure 1). (You may need to gently push the bottom edge of the caps in with
the end of a small screwdriver to start them.) Remove the two screws hidden
underneath (see Figure 2). Gently swing the lower side of the front out from
the back box by about 10mm and then slide the front upwards to disengage
the top catches. (Be careful not to pull the lower side of the front more than
about 25mm away from the back while the top catches are engaged, or you
may break the catches.)
Figure 3 shows the cable entries and fixing holes in the back box.
The front plastic housing contains the printed circuit board (pcb) see Figure 5:
Technical Specifications
Manufacturer Cooper Security Ltd
Product code KEY-KP01
Standards EN50131-3
Security Grade 3
Environmental Class II.
Operating temperature -10 to +55°C.
Humidity 0 to 93% RH, non-condensing.
Dimensions: 128 x 128 x 29, mm HxWxD
Keypad weight: 0.19 kg
Case material ABS
Current Consumption 65mA max backlight ON, prox reader connected
35mA max backlight OFF, internal prox reader only.
KEY-EP External prox reader
Security Grade 3
Environmental Class IV
Dimensions 58x34x19 mm, HxWxD
Weight (incl 2m cable) 95gm
Compliance
The KEY-KP01 complies with EN50131-3:2009 at security Grade 2 or 3 when
correctly installed with any i-on range control unit or Menvier30/40/100/300.
Third party testing carried out by ANPI.