•
Check the tire inflation
Inflate the tires to the air pressure recommended
on the tire sidewalls.
•
Check the brakes
Follow the inspection instructions
for the type of brake on your bike:
A hand lever connected to the brake by a cable
allows the brake pads to squeeze the rim.
When the brakes are not applied, the brake pads
should be 1 to 2 mm from the rim. Squeeze each
brake lever toward the handlebar to make sure the
brake moves freely and stops the bike. If the brake
lever can be pulled to the handlebar, the brake is too loose.
If the brake pads are too close to the rim, the brake is too tight.
Brake pads should be aligned with the rim surface.
WARNING
Never ride a bike if you are not certain the brakes are working properly, or you if suspect a problem
with the brake cables or hydraulic hose. Malfunctioning brakes can cause you to lose control and fall.
Inspect the brakes thoroughly before every ride. If your brakes are not working properly, re-adjust
them or take the bike to your dealer for service
.
12
Cooper
Bicycle Owners Manual
The Brakes
A - Brake pad alignment with wheel rim surface
B - Brake pad set parallel to rim
C - Direction of wheel rotation
D - 0.5 - 1.0mm toe out
MANUAL 20.11.12 2/7/13 00:00 Page 17
