Cooper Sound CS 208, Operator'S Manual

Page: 25 / 36

MODEL CS 208
23
Insert: Post HP filters, EQ. & Limiter.
Send and return to auxiliary equipment (eg: outboard compressor/limiter, equalizers and multi-track
recorders). Can be changed to direct out, pre-fader only. (See application note AN 2A & 2B.)
Direct Out: Post channel fader (eg: feed to playback systems, direct feed to multi-track recorders).
2 Holes
above Ch.
1 & 2 on
rear panel:
Machined for XLR connectors (eg: stereo input channels).
(General: All internal jumpers are mechanical, do not require soldering.)
Output Section
4 main + 2 aux outs.
SL (slate):
Down = Slate + 27 HZ LF tone.
For slating takes where an LF tone is desired. The tone is set at -16 dB on the PPM meters. When the
takes are played back at high speed, the LF tone becomes audible to indicate the front end of recorded
takes. Internal trimmer adjusts this LF tone level.
Up = no LF tone. (Slate to outputs assigned by AB, CD, Aux. switches.)
Osc.
(oscillator):
Level set by trimmer above this switch. Frequency selected by push button switch above the
level trimmer.
Ext. Slate: Up = Internal, Down = External. (See rear panel.)
Slate amp. level controlled by trimmer below this switch.
Roll 1, 2: Center off switches.
Can independently control recorders, depending on the pins selected on the roll connectors on the rear
panel. (See application note AN 1.)
Up = Record.
Down = Stop, pause.
PL
(private
line):
Can be assigned to Phones 1, 2 or 3.
Level controlled by trimmer above the switch.
AB, CD,
Aux:
Assigns slate and oscillator to these outputs.
Mic: Internal slate mic.
Phones
1’ Section:
Main phones out, two jacks are provided on front panel.
Main = ABCD: AB or CD sub-selected on right.
Aux = 1, 2 Left = A1, Right = A2. (See phones select.)
OPERATION & APPLICATION NOTES
Left Page
Left Page